AMP EFI MS3Pro - EAE Adhere-To-Walls CLT Correction; EAE Adhere-To-Walls RPM Correction; EAE Sucked-From-Walls RPM Correction

To Next Page

To Previous Page

7.5 Accel Enrich 7 ADDITIONAL ITEMS: BEYOND BASIC FUEL AND IGNITION CONTROL

7.5.2.3 EAE Adhere-to-walls RPM correction

This curve modiﬁes the EAE Adhere-to-walls curve. It allows the amount of correction speciﬁed by the EAE

Adhere-to-walls curve to be increased or decreased based on RPM. As you may expect, the higher ﬂow rates at

higher RPM tend to carry more of the fuel into the cylinders and result in less on the walls.

7.5.2.4 EAE Sucked-from-walls RPM correction

This curve modiﬁes the EAE Sucked-from-walls curve. It allows the amount of correction speciﬁed by the EAE

Sucked-from-walls curve to be increased or decreased based on RPM. The increased ﬂow rate at higher RPM

tends to pull more fuel off the walls as well as preventing as much of it from sticking in the ﬁrst place.

7.5.2.5 EAE Adhere-to-walls CLT correction

AMP EFI MS3Pro manual version 1.202, ﬁrmware 1.5.0, 4/21/2017 Page 196