7.10 CAN bus / Testmodes 7 ADDITIONAL ITEMS: BEYOND BASIC FUEL AND IGNITION CONTROL
Note that Full Sequential and Semi Sequential modes only work if the engine is already configured to run in
these modes. Clicking Stop Testing reverts to the existing settings.
7.10.18 Inj / Spk Disabling Test Mode
Looking for a dead cylinder? Instead of unplugging the injectors or coils to check for a cylinder that’s not working,
the MS3Pro lets you shut down individual cylinders through TunerStudio. Note that you need enough inputs for
full sequential operation to allow for disabling cylinders. Click the cylinder buttons to disable the coil or injector
associated with that cylinder.
7.10.19 Special options
These are highly specialized options; most users will not need to ever touch them.
AMP EFI MS3Pro manual version 1.202, firmware 1.5.0, 4/21/2017 Page 277
To Next Page
Loading...