AMP EFI MS3Pro - 21 Throttle Control (DBW)

7.10 CAN bus / Testmodes 7 ADDITIONAL ITEMS: BEYOND BASIC FUEL AND IGNITION CONTROL
• Burn interval - Minimum time, in minutes, before updating the long term trim to flash.
• LED output - Turns on an output when the amount of trim change exceeds the total change threshold, to let
you know the ECU needs the trim to be burned to flash.
• Total change before burning - In timed write mode, the MS3Pro will automatically burn the trim table to
flash if it changes by this large a percentage. In button mode, this will turn on the LED indicator.
• Display current % change in sensor 15 - Allows using the Sensor 15 generic sensor to read the percent of
change to long term trim.
• Read Table 1 to RAM - This takes the saved table #1 and copies it to the working RAM area.
• Read Table 2 to RAM - This takes the saved table #2 and copies it to the working RAM area.
• Burn Table to Flash - This takes the saved table #1 and copies it to the working RAM area.
• Zero Tables - This resets the working table and two saved tables to zero trim. It should be used after tuning
the VE table.
7.10.21 Throttle control (DBW)
These settings allow the MS3Pro to transmit CAN messages to a planned external module used for interfacing
with a GM TAC external throttle control module. The interface module has not yet been released. Documentation
for these settings will be released when the interface module is ready.
AMP EFI MS3Pro manual version 1.202, firmware 1.5.0, 4/21/2017 Page 279