AMP EFI MS3Pro - Map; Puddling) Temp Correction Factors; Tau (Time) Temp Corrections

To Next Page

To Previous Page

7.5 Accel Enrich 7 ADDITIONAL ITEMS: BEYOND BASIC FUEL AND IGNITION CONTROL

7.5.3.3 X (Puddling) Temp Correction Factors

The temperature correction factors are enabled if you enable X-Tau with CLT correction. This is a percent

multiplier used to scale the accel and decel puddling factor curves as a function of coolant temperature.

7.5.3.4 Tau (Time) temp corrections

This is a percent multiplier used to scale the time factor accel and decel curves as a function of temperature.

7.5.3.5 MAP

This determines whether to use the accel or decel tables. If MAPdot is above the start transition threshold, the

X-Tau accel tables are used. If MAPdot is less than (i.e., more negative than) the ﬁnish transition threshold, the

the X-Tau Decel tables are used. If MAPdot is in between, a blend of the 2 tables is used. Note that these are in

negative kPa (i.e., put 40 if you want the threshold to be at -40 kPa/sec).

AMP EFI MS3Pro manual version 1.202, ﬁrmware 1.5.0, 4/21/2017 Page 199