7.6 Boost / VVT 7 ADDITIONAL ITEMS: BEYOND BASIC FUEL AND IGNITION CONTROL
This specifies how long to go from no boost (if the initial value is not used) or the specified initial value (if used)
to full boost after you release the launch control switch. This is a percentage of the regular boost, so it should end
at 100% boost.
7.6.7 Boost control vs speed
This allows you to specify the amount of boost allowed (closed loop) or solenoid duty cycle (open loop) as a
function of ground speed.
7.6.8 Boost 2 control settings
The boost control 2 menu is for twin turbo setups, either sequential or compound. Use these settings if you have
a second solenoid valve controlling a second wastegate independently of the primary wastegate. Setups that use
a single solenoid to control two wastegates do not need these settings. As the screen notes, you cannot use this
with timed, speed, or switched boost control.
• Boost control enabled - allows a second solenoid output using the second set of boost tables.
• Boost control pin - specifies which output to use for the second solenoid.
AMP EFI MS3Pro manual version 1.202, firmware 1.5.0, 4/21/2017 Page 207
To Next Page
Loading...