Measurement Results
110
The Trace Display Window can easily be configured to display traces of
Torque and Angle, Torque and Time or, as shown below on the left, Torque
and Angle over Time. Refer to the chapter entitled Programming the ACTA
3000, menu block “Param.” (Parameters) for instructions.
Torque and Angle over Time Graph
The Trace Display Window also features a Zoom function. If an area of the tightening
operation curve needs to be studied in detail, it can be magnified by zooming-in up to
five times. Refer to the chapter entitled Programming the ACTA 3000, menu block
“Param” (Parameters) for instructions.
Cancel
To Next Page
Loading...
