Atlas Copco ACTA 3000

Technical Specifications
193
2. RS232
PowerMac
Tool type Direct driven
Target torque Read from controller
Calibration torque Read from controller
Parameter set Read from controller
Controller Power Macs
Communication RS232
Cell ID 0
Channel 1
Model Tensor S
Filter frequency 500 Hz
Rotation direction CW
Measure strategy Peak
Cycle start Read from controller
Cycle complete Read from controller
Start angle Read from controller
Angle complete Read from controller
Measure delay time 0
Reset time 0
End time Read from controller
Slip torque
20
0.1 Nm
Batch size Read from controller
Subgroup size Read from controller
Subgroup frequency 1
Batch result Off
Torque min. Read from controller
Torque max. Read from controller
Torque LCLx Read from controller
Torque UCLx Read from controller
Torque LCLr Read from controller
20
Not used for direct driven tool.