Programming
73
5. When all parameters have been set according to your preference, highlight
OK and press ‘Enter’ or simply press the ‘OK’ button on the keypad.
Angle setup is now complete and saved and the pop-up dialog box
disappears.
If you need to exit the Angle setup prematurely before setting your preferences,
highlight Cancel and then press ‘Enter’ or simply press the menu block showing
Cancel. None of the preferences for the above parameters will then take effect.
Setting Pulse (setup)
1. Re-open the Prog. menu block, select 4. Statistical setup.
2. Open 4. Pulse and a pop-up dialog box with two parameters appears:
1. No. of pulses, min. Sets the minimum number of pulses for the
measurement
2. No. of pulses, max. Sets the maximum number of pulses for the
measurement.
3. Use the arrows to highlight (select) the above parameters. Open each
parameter by pressing ‘Enter’.
4. Manually input your preferred values in each parameter. All inputs are
numerical values. Press ‘Enter’ to confirm each input.
5. When all parameters have been set according to your preference, highlight
OK and press ’Enter’ or simply press the ‘OK’ button on the keypad. Pulse
setup is now complete and saved and the pop-up dialog box disappears.
If you need to exit the Pulse setup prematurely before setting your preferences,
highlight Cancel and then press ‘Enter’ or simply press the menu block showing
Cancel. None of the preferences for the above parameters will then take effect.
To Next Page
Loading...
