Atlas Copco ACTA 3000

Programming
76
Torque units
Sets the units used for the torque in this tool.
1. Nm
2. ozf.in
3. lbf.in
4. lbf.ft
5. kgt.m
6. kgf.cm
Parameter 2
This parameter is displayed on the left of the ACTA 3000 custom measurement display,
below Parameter 1. When this parameter is opened a pop-up dialog box appears for you to
select one of the following options:
1. Torque (Torque) will display the torque value
2. Angle (Angle) will display the angle value
3. No. of pulses (No. of Pulses) will display the number of pulses
4. C. torque Will display the controller torque value.
5. C. angle Will display the controller angle value.