Version 6.2 371 February 2011
SIP User's Manual 10. Configuration Parameters Reference
Parameter Description
Web: Authentication Table
EMS: SIP Endpoints > Authentication
[Authentication]
This ini file table parameter defines a user name and password
for authenticating each device port. The format of this
parameter is as follows:
[Authentication]
FORMAT Authentication_Index = Authentication_UserId,
Authentication_UserPassword;
[\Authentication]
Where,
Index = port number (where 0 depicts the Port 1)
UserId = User name
UserPassword = Password
For example:
Authentication 0 = john,1325; (user name "john" with password
1325 for authenticating Port 1)
Authentication 1 = lee,1552; (user name "lee" with password
1552 for authenticating Port 2)
Notes:
The parameter AuthenticationMode determines whether
authentication is performed per port or for the entire device.
If authentication is performed for the entire device, the
configuration in this table parameter is ignored.
If the user name or password is not configured, the port's
phone number (configured using the parameter TrunkGroup
- Endpoint Phone Number table) and global password
(using the individual parameter Password) are used for
authentication.
Authentication is typically used for FXS interfaces, but can
also be used for FXO interfaces.
For configuring the Authentication table using the Web
interface, see Configuring Authentication on page 153.
For an explanation on using ini file table parameters, see
''Configuring ini File Table Parameters'' on page 194.
To Next Page
Loading...
