Version 6.2 399 February 2011
SIP User's Manual 10. Configuration Parameters Reference
Parameter Description
[2] Transmit Only= Send RTP only
[3] Receive Only= Receive RTP only
Notes:
To configure the RTP Only mode per trunk, use the
RTPOnlyModeForTrunk_ID parameter.
If per trunk configuration (using the RTPOnlyModeForTrunk_ID
parameter) is set to a value other than the default, the
RTPOnlyMode parameter value is ignored.
Web/EMS: SIT Q850
Cause
[SITQ850Cause]
Determines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when a Special Information Tone
(SIT) is detected on an IP-to-Tel call.
The valid range is 0 to 127. The default value is 34.
Notes:
For mapping specific SIT tones, you can use the
SITQ850CauseForNC, SITQ850CauseForIC, SITQ850CauseForVC,
and SITQ850CauseForRO parameters.
This parameter is applicable only to FXO interfaces.
Web/EMS: SIT Q850
Cause For NC
[SITQ850CauseForNC]
Determines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-NC (No Circuit Found
Special Information Tone) is detected from the Tel for IP-to-Tel calls.
The valid range is 0 to 127. The default value is 34.
Notes:
When not configured (i.e., default), the SITQ850Cause parameter is
used.
This parameter is applicable only to FXO interfaces.
Web/EMS: SIT Q850
Cause For IC
[SITQ850CauseForIC]
Determines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-IC (Operator Intercept
Special Information Tone) is detected from the Tel for IP-to-Tel calls.
The valid range is 0 to 127. The default value is -1 (not configured).
Notes:
When not configured (i.e., default), the SITQ850Cause parameter is
used.
This parameter is applicable only to FXO interfaces.
Web/EMS: SIT Q850
Cause For VC
[SITQ850CauseForVC]
Determines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-VC (Vacant Circuit - non-
registered number Special Information Tone) is detected from the Tel
for IP-to-Tel calls.
The valid range is 0 to 127. The default value is -1 (not configured).
Notes:
When not configured (i.e., default), the SITQ850Cause parameter is
used.
This parameter is applicable only to FXO interfaces.
Web/EMS: SIT Q850
Cause For RO
[SITQ850CauseForRO]
Determines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-RO (Reorder - System
Busy Special Information Tone) is detected from the Tel for IP-to-Tel
calls.
The valid range is 0 to 127. The default value is -1 (not configured).
Notes:
When not configured (i.e., default), the SITQ850Cause parameter is
To Next Page
Loading...
