SIP User's Manual 400 Document #: LTRT-65415
MediaPack Series
Parameter Description
used.
This parameter is applicable only to FXO interfaces.
Out-of-Service (Busy Out) Parameters
Web/EMS: Enable Busy
Out
[EnableBusyOut]
Determines whether the Busy Out feature is enabled.
[0] Disable = 'Busy out' feature is not used (default).
[1] Enable = 'Busy out' feature is enabled.
When Busy Out is enabled and certain scenarios exist, the device
performs the following:
A reorder tone (configured by the parameter FXSOOSBehavior) is
played when the phone is off-hooked.
These behaviors are performed upon one of the following scenarios:
Physically disconnected from the network (i.e., Ethernet cable is
disconnected).
The Ethernet cable is connected, but the device can't communicate
with any host. Note that LAN Watch-Dog must be activated (the
parameter EnableLANWatchDog set to 1).
The device can't communicate with the proxy (according to the Proxy
Keep-Alive mechanism) and no other alternative route exists to send
the call.
The IP Connectivity mechanism is enabled (using the parameter
AltRoutingTel2IPEnable) and there is no connectivity to any
destination IP address.
Notes:
The FXSOOSBehavior parameter determines the behavior of the
FXS endpoints when a Busy Out or Graceful Lock occurs.
FXO endpoints during Busy Out and Lock are inactive.
See the LifeLineType parameter for complementary optional
behavior.
Web: Out-Of-Service
Behavior
EMS:FXS OOS Behavior
[FXSOOSBehavior]
Determines the behavior of undefined FXS endpoints and all FXS
endpoints when a Busy Out condition exists.
[0] None = Normal operation. No response is provided to undefined
endpoints. A dial tone is played to FXS endpoints when a Busy Out
condition exists.
[1] Reorder Tone = The device plays a reorder tone to the connected
phone/PBX (default).
[2] Polarity Reversal = The device reverses the polarity of the
endpoint marking it unusable (relevant, for example, for PBX DID
lines). This option can't be configured on-the-fly.
[3] Reorder Tone + Polarity Reversal = Same as 2 and 3 combined.
This option can't be configured on-the-fly.
[4] Current Disconnect = The device disconnects the current of the
FXS endpoint. This option can't be configured on-the-fly.
Note: This parameter is applicable only to FXS interfaces.
To Next Page
Loading...
Need help?
General
