SIP User's Manual 476 Document #: LTRT-65415
MediaPack Series
Parameter Description
Notes:
For defining the channel select mode per Hunt Group, see
''Configuring Hunt Group Settings'' on page 126.
The phone numbers of the device's channels are defined by
the TrunkGroup parameter.
Web: Default Destination Number
[DefaultNumber]
Defines the default destination phone number, which is used if
the received message doesn't contain a called party number and
no phone number is configured in the 'Endpoint Phone Number
Table' (see to Configuring Endpoint Phone Numbers on page
124). Thi
s parameter is used as a starting number for the list of
channels comprising all the device's Hunt Groups.
The default value is 1000.
Web: Source IP Address Input
[SourceIPAddressInput]
Determines the IP address that the device uses to determine the
source of incoming INVITE messages for IP-to-Tel routing.
[-1] = Not configured. (default)
[0] SIP Contact Header = The IP address in the Contact
header of the incoming INVITE message is used.
[1] Layer 3 Source IP = The actual IP address (Layer 3) from
where the SIP packet was received is used.
Web: Use Source Number As
Display Name
EMS: Display Name
[UseSourceNumberAsDisplayNa
me]
Determines the use of Tel Source Number and Display Name for
Tel-to-IP calls.
[0] No = If a Tel Display Name is received, the Tel Source
Number is used as the IP Source Number and the Tel
Display Name is used as the IP Display Name. If no Display
Name is received from the Tel side, the IP Display Name
remains empty (default).
[1] Yes = If a Tel Display Name is received, the Tel Source
Number is used as the IP Source Number and the Tel
Display Name is used as the IP Display Name. If no Display
Name is received from the Tel side, the Tel Source Number
is used as the IP Source Number and also as the IP Display
Name.
[2] Overwrite = The Tel Source Number is used as the IP
Source Number and also as the IP Display Name (even if the
received Tel Display Name is not empty).
Web/EMS: Use Display Name as
Source Number
[UseDisplayNameAsSourceNum
ber]
Determines the use of Source Number and Display Name for IP-
to-Tel calls.
[0] No = If IP Display Name is received, the IP Source
Number is used as the Tel Source Number and the IP
Display Name is used as the Tel Display Name. If no Display
Name is received from IP, the Tel Display Name remains
empty (default).
[1] Yes = If an IP Display Name is received, it is used as the
Tel Source Number and also as the Tel Display Name, and
Presentation is set to Allowed (0). If no Display Name is
received from IP, the IP Source Number is used as the Tel
Source Number and Presentation is set to Restricted (1).
For example: When 'From: 100 <sip:200@201.202.203.204>' is
received, the outgoing Source Number and Display Name are
set to '100' and the Presentation is set to Allowed (0).
When 'From: <sip:100@101.102.103.104>' is received, the
outgoing Source Number is set to '100' and the Presentation is
set to Restricted (1).
To Next Page
Loading...
Need help?
General
