SIP User's Manual 478 Document #: LTRT-65415
MediaPack Series
Parameter Description
Web: IP to Hunt Group Routing Table
EMS: SIP Routing > IP to Hunt
[PSTNPrefix]
This ini file table parameter configures the routing of IP calls to
Hunt Groups. The format of this parameter is as follows:
[PSTNPrefix]
FORMAT PstnPrefix_Index = PstnPrefix_DestPrefix,
PstnPrefix_TrunkGroupId, PstnPrefix_SourcePrefix,
PstnPrefix_SourceAddress, PstnPrefix_ProfileId,
PstnPrefix_SrcIPGroupID, PstnPrefix_DestHostPrefix,
PstnPrefix_SrcHostPrefix;
[\PSTNPrefix]
For example:
PstnPrefix 0 = 100, 1, 200, *, 0, 2, , ;
PstnPrefix 1 = *, 2, *, , 1, 3, acl, joe;
Notes:
This parameter can include up to 24 indices.
For a description of the table's parameters, refer to the
corresponding Web parameters in ''Configuring IP to Hunt
Group Routing Table'' on page 142.
To support the In-Call Alternative Routing feature, you can
use two entries that support the same call but assigned with
a different Hunt Group. The second entry functions as an
alternative route if the first rule fails as a result of one of the
release reasons configured in the AltRouteCauseIP2Tel
table.
Selection of Hunt Groups (for IP-to-Tel calls) is according to
destination number, source number,and source IP address.
The source IP address (SourceAddress) can include the 'x'
wildcard to represent single digits. For example: 10.8.8.xx
represents all IP addresses between 10.8.8.10 and
10.8.8.99.
The source IP address (SourceAddress) can include the
asterisk ('*') wildcard to represent any number between 0 and
255. For example, 10.8.8.* represents all addresses between
10.8.8.0 and 10.8.8.255.
If the source IP address (SourceAddress) includes an FQDN,
DNS resolution is performed according to the parameter
DNSQueryType.
For available notations for depicting a range of multiple
numbers, see ''Dialing Plan Notation for Routing and
Manipulation'' on page 228.
For a description on using ini file table parameters, see
''Configuring ini File Table Parameters'' on page 194.
Web/EMS: IP to Tel Routing Mode
[RouteModeIP2Tel]
Determines whether to route IP calls to the Hunt Group before or
after manipulation of the destination number (configured in
''Configuring Number Manipulation Tables'' on page 129).
[0] Route calls before manipulation = Calls are routed before
the number manipulation rules are applied (default).
[1] Route calls after manipulation = Calls are routed after the
number manipulation rules are applied.
To Next Page
Loading...
