Azbil C1M - Password

5-104
Chapter 5. Functions

Password
If a password is set (password lock), key-locked items whose settings cannot be
changed using the keys will not be displayed.
Item (bank) Display Description Initial value User level
Password display
(lock bank)
PASS
0 to 15
5: Displays passwords 1A to 2B
0
(0 is set at
power-on)
Simple,
standard,
advanced
Password 1A
(lock bank)
PS1A
0000 to FFFF (hex) 0000
Password 2A
(lock bank)
PS2A
0000 to FFFF (hex) 0000
Password 1B
(lock bank)
PS1B
0000 to FFFF (hex) 0000
Password 2B
(lock bank)
PS2B
0000 to FFFF (hex) 0000
• PS1A (password 1A) and PS2A (password 2A) are displayed and the settings can
be changed if PASS (password display) is set to 5 and the two sets of passwords
(1A and 1B, 2A and 2B) match.
• PS1B (password 1B) and Ps2b (password 2B) are displayed and the settings can be
changed if PASS (password display) is set to 5.
• The value set for PS1A (password 1A) is automatically set for PS1B (password 1B).
• The value set for PS2A (password 2A) is automatically set for PS2b (password 2B).
Handling Precautions
• Before setting passwords 1A to 2B, decide on two hexadecimal numbers
that will be the passwords, and make a note so that you will remember
them.
• PASS is provided to prevent accidental changing of passwords by
restricting the display conditions of passwords 1A to 2B.
• If you set a value for passwords 1A and 2A and then set a different
value for passwords 1B and 2B, passwords 1A and 2A will no longer be
displayed, and the settings for key lock, communication lock, and loader
lock cannot be changed. This is called a password locked state.
• Settings that cannot be changed due to key lock cannot be displayed in
the password locked state.
• If the password lock cannot be reset, initialize settings from the
[Calibration and checking] screen of Smart Loader Package model SLP-
C1F. In this case, any settings configured by the user will also be initialized
(lost).