3-1
Chapter 3. Installation
WARNING
To prevent electrical shock, this device must be installed in a location that is only accessible to
people with appropriate knowledge about electrical safety. Install this device inside a control
panel that cannot be opened without the use of a key or tool.
Do not use this device in an environment with conductive contamination, or with dry non-
conductive contamination which can become conductive due to condensation, etc.
Otherwise, problems such as tracking phenomena may damage parts, resulting in fire.
Before removing, mounting, or wiring this device, be sure to turn off the power to this device
and all connected devices. After wiring this device, attach the separately sold terminal cover
(model No. 84515888-001). Otherwise, there is a danger of electric shock.
Do not touch live parts such as the power terminals. There is a danger of electric shock.
Do not disassemble this device. There is a danger of electric shock or device failure.
WARNING
Use this device within the operating ranges given in the specifications (for temperature,
humidity, voltage, vibration, shock, mounting direction, atmosphere, etc.). Otherwise, there is
a danger of fire or device failure.
Do not block the ventilation holes. There is a danger of fire or device failure.
Do not allow wire clippings, metal shavings, water, etc., to enter the case of this device. There
is a danger of fire or device failure.
To Next Page
Loading...
