List of Error Messages
6-26
Troubleshooting
6
List of Error Messages
Self-diagnostic Display
If a self-diagnostic message appears, follow the instructions on the touch panel display.
Self-diagnostic (error) messages appear on the touch panel display at the following times:
• When printing cannot be performed because of an operational error.
• When you need to make a judgment or take some action during scanning or printing.
Add paper.
Cause The machine has run out of paper. No more prints can be made.
The paper drawer is not correctly inserted.
Remedy Load paper. (See ‘Loading Paper,’ on p. 5-2.)
Insert the paper drawer as far as it will go. (See ‘Loading Paper,’ on p. 5-2.)
Load LTR-size paper.
Cause The paper drawer loaded with the best paper size, selected by the Automatic
Paper selection mode, is not inserted into the machine.
Remedy Load the indicated paper size in a paper drawer.
If you press (Start) while this message is displayed, prints will be made with
the currently selected paper.
If the message remains even when the indicated paper is loaded, set the drawer
eligibility for APS/ADS of that paper drawer to “On.” (See ‘Setting a Paper Drawer
for Auto Paper Selection/Auto Drawer Switching,’ on p. 3-13.)
Return page 1 to the top, and press “Start.”
Cause Scanning was stopped due to a problem with the feeder.
Remedy Arrange the originals in page order with the first page on top. Place the originals
back in the feeder’s original supply tray, and press (Start).
E1L_US_U_.book-INDEX Page 26 Wednesday, May 23, 2001 11:40 PM
To Next Page
Loading...
