1
Entering Characters from the Touch Panel Display
1-34
Before You Start Using This Machine
To enter a space, press “Space.”
To move the cursor, press “ ” or “ .”
To enter alphabet characters, press “Entry Mode” before you press “OK” to select
“Alphabet.”
NOTE
•
If you make a mistake when entering special letters, use “ ” or “ ” to position the cursor,
and “Backspace” to delete the character. Then, enter the correct character.
•
You can also delete all characters you have entered by pressing (Clear).
•
The available modes and maximum number of letters vary depending on the entry field.
4
When you have finished entering the special characters, press “OK.”
E1L_US_U_.book-INDEX Page 34 Wednesday, May 23, 2001 11:40 PM
To Next Page
Loading...
