Cisco 8811 Administration Guide

Description and Usage GuidelinesDefaultField Type
or Choices
Field Name
Controls the ringing pattern.DefaultDefault
Japan
Ring Locale
Controls the ability to resume a TLS session without repeating
the entire TLS authentication process. If the field is set to 0,
then the TLS session resumption is disabled.
3600
Integer 0–3600
seconds
TLS Resumption
Timer
Enables or disables the Federal Information Processing
Standards (FIPS) mode on the phone.
DisabledDisabled
Enabled
FIPS Mode
Specifies whether to record a shared line call in the call log.DisabledDisabled
Enabled
Record Call Log from
Shared Line
Controls the minimum ring volume for the phone.
You can set a phone so that the ringer cannot be turned off.
0-Silent0-Silent
1–15
Minimum Ring
Volume
Allows the phone to find other phones of the same model on
the subnet and share updated firmware files. If the phone has
a new firmware load, it can share that load with the other
phones. If one of the other phones has a new firmware load,
the phone can download the firmware from the other phone,
instead of from the TFTP server.
Peer firmware sharing:
•
Limits congestion on TFTP transfers to centralized
remove TFTP servers.
•
Eliminates the need to manually control firmware
upgrades.
•
Reduces phone downtime during upgrades when large
numbers of phones are reset simultaneously.
•
Helps with firmware upgrades in branch or remote office
deployment scenarios that run over bandwidth-limited
WAN links.
EnabledDisabled
Enabled
Peer Firmware
Sharing
Identifies the alternate IPv4 server that the phone uses to obtain
firmware loads and upgrades.
The format for the address is:
address:<port>@@base=<0-7>;pfs=<0-1>
String of up to 256
characters
Load Server
Identifies the alternate IPv6 server that the phone uses to obtain
firmware loads and upgrades.
The format for the address is:
[address]:<port>@@base=<0-7>;pfs=<0-1>
String of up to 256
characters
IPv6 Load Server
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
145
Phone Feature Configuration

Cisco 8811 Specifications

General

Ethernet Ports	2 x 10/100/1000
Lines Supported	5
Speakerphone	Yes
Headset Port	Yes
USB Port	No
Bluetooth	No
Wi-Fi	No
Resolution	800 x 480 pixels
PoE	Yes, IEEE 802.3af Class 2
Audio Codec Support	G.711, G.722, G.729, iLBC
Protocols	SIP
Display	5-inch, 800 x 480 pixels
Headset Jack	RJ9
Weight	1.1 kg