New Information for Firmware Release 11.5(1)
Table 3: Cisco IP Phone 8800 Administration Guide revisions for Firmware Release 11.5(1).
Updated SectionRevision
Set Up Additional Line Keys, on page 189
Features Available in Enhanced Line Mode, on page
190
Enhanced line mode is supported.
Set Up Do Not Disturb, on page 161Do Not Disturb (DND) was updated for new display.
Phone Overview, on page 23Opus codec is supported.
Enable FIPS Mode, on page 90FIPS Mode was added.
Set Up Wireless LAN from Phone, on page 44WLAN setup was updated.
Set Up a Wi-Fi Profile, on page 47WLAN Profile for Cisco IP Phone 8861 and 8865 is
supported.
Set Up a Wi-Fi Group, on page 49
Set WLAN Authentication Attempts, on page 47Set WLAN Authentication Attempts is supported.
Enable WLAN Prompt Mode, on page 47Enable WLAN Prompt Mode is supported.
Customize the Dial Tone, on page 115Customize Dial Tone is supported.
Display Network Information Screen, on page 208Display Network Info Screen is supported.
New Information for Firmware Release 11.0
All new features have been added to Telephone Features, on page 118.
All references into Cisco Unified Communications Manager documentation have been updated to support all
Cisco Unified Communications Manager releases.
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
3
New and Changed Information
New Information for Firmware Release 11.5(1)
To Next Page
Loading...
Need help?
General
