To changeDescriptionOption
Scroll to IPv6 setup and press Select.In the IPv6 setup configuration submenu,
you can do the following:
•
Enable or disable the phone to use the
IPv6 address that is either assigned by
DHCPv6 server or acquired by SLAAC
through an IPv6-enabled router.
•
Manually set the IPv6 Address, Prefix
Length, Default Routers, DNS Server,
and Alternate TFTP servers.
For more information about the IPv6 address
fields, see Set Up IPv6, on page 56.
IPv6 setup
Display only. Cannot configure.Unique Media Access Control (MAC)
address of the phone.
MAC address
See Set Domain Name Field, on page
59.
Name of the Domain Name System (DNS)
domain in which the phone resides.
Domain name
See Set SSID Field, on page 61.
You can modify SSID field only if the
phone is configured without wireless
LAN profile or the profile with allowed
profile.
Specifies the Service Set Identifier, a unique
identifier for accessing wireless access
points.
The User Modifiable field controls access
to this field.
SSID
See Set Security Mode Field, on page
61.
The type of authentication that the phone
uses to access the WLAN.
If the User Modifiable field is set to
Restricted, and the authentication mode is
EAP-FAST, PEAP-GTC,
PEAP-MSCHAPv2, the Security mode field
is available. Otherwise, the field is not
available.
Security mode
See Set 802.11 Mode Field, on page
62 .
Specifies the wireless signal standard that is
used in the WLAN.
The User Modifiable field controls access
to this field.
802.11 mode
Step 4
Press Save to make changes or press Revert to discard the connection.
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
46
Set up Wireless LAN
To Next Page
Loading...
Need help?
General
