Cisco Catalyst 3550 - Page 787

Index
IN-13
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
QoS (continued)
queues
tail-drop threshold percentages 2-667
WRED threshold percentages 2-665
WRR weights 2-656
statistics
collecting on specified DSCPs 2-256
displaying DSCP information 2-440
tail-drop
assigning threshold percentages 2-667
mapping DSCPs to thresholds 2-660
trusted boundary for Cisco SoftPhones 2-258
trusted boundary for IP phones 2-258
WRED
assigning threshold percentages 2-665
enabling 2-665
mapping DSCPs to thresholds 2-660
quality of service
See QoS
querytime, MVR 2-265
R
radius-server dead-criteria command 2-292
rapid per-VLAN spanning-tree plus
See STP
rapid PVST+
See STP
rcommand command 2-294
re-authenticating IEEE 802.1x-enabled ports 2-103
re-authentication
periodic 2-105
time between attempts 2-106
receiver ports, MVR 2-268
receiving flow-control packets 2-117
recovery mechanism
causes 2-113
display 2-351
timer interval 2-113
redundancy for cluster switches 2-66
remote-span command 2-296
Remote Switched Port Analyzer
See RSPAN
rename (boot loader) command A-17
reset (boot loader) command A-18
reset command 2-634
resource templates, displaying 2-468
restricted VLAN
See dot1x auth-fail VLAN
rmdir (boot loader) command A-19
rmon collection stats command 2-297
root guard, for spanning tree 2-530
route distinguisher 2-198
routed ports
IP addresses on 2-130
number supported 2-130, 2-300
route-target command 2-198
RSPAN
and IDS 2-263
configuring 2-261
displaying 2-446
filter RSPAN traffic 2-261
remote-span command 2-296
sessions
add interfaces to 2-261
start new 2-261
S
sdm prefer command 2-299
secure ports, limitations 2-591
sending flow-control packets 2-117
service password-recovery command 2-302
service-policy command 2-305
set (boot loader) command A-20
set command 2-307
setup command 2-309
setup express command 2-312