2-471
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show interfaces
Note Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting,
precedence, random-detect, rate-limit, and shape keywords are not supported.
Command Modes Privileged EXEC
Command History
Usage Guidelines The show interfaces capabilities command with different keywords has these results:
• Entering show interface capabilities module 1displays the capabilities of all interfaces on the
switch. If you enter a number other than 1, the output is blank. This keyword is not available if you
enter a specific interface ID before the capabilities keyword.
• Entering show interfaces interface-id capabilities displays the capabilities of the specified
interface.
• Entering show interfaces capabilities (with no module number or interface ID) displays the
capabilities of all interfaces on the switch.
The vlan mapping option is available only when you have entered any interface-ID or vlan vlan-id;
however, the display shows VLAN mapping information only for ES ports.
Examples This is an example of output from the show interfaces command for an interface:
Switch# show interfaces gigabitethernet0/2
GigabitEthernet0/2 is up, line protocol is up (connected) (vlan-err-dis)
Hardware is Gigabit Ethernet, address is 0018.1902.cd02 (bia 0018.1902.cd02)
MTU 1548 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 1000Mb/s, link type is auto, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
12112813 packets input, 801716512 bytes, 0 no buffer
Received 2001806 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 2001806 multicast, 0 pause input
0 input packets with dribble condition detected
11935759 packets output, 783067011 bytes, 0 underruns
Release Modification
12.1(14)AX This command was introduced.
12.2(25)EY The backup, properties, and private-vlan mapping keywords were added.
12.2(25)SEE Added the backup, counters, detail, and trunk keywords.