EasyManua.ls Logo

Cisco Catalyst 3750 Metro - Page 500

Cisco Catalyst 3750 Metro
985 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-472
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show interfaces
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
This is an example of output from the show interfaces accounting command.
Switch# show interfaces accounting
Vlan1
Protocol Pkts In Chars In Pkts Out Chars Out
IP 1094395 131900022 559555 84077157
Spanning Tree 283896 17033760 42 2520
ARP 63738 3825680 231 13860
Interface Vlan2 is disabled
Vlan7
Protocol Pkts In Chars In Pkts Out Chars Out
No traffic sent or received on this interface.
Vlan31
Protocol Pkts In Chars In Pkts Out Chars Out
No traffic sent or received on this interface.
GigabitEthernet1/0/1
Protocol Pkts In Chars In Pkts Out Chars Out
No traffic sent or received on this interface.
GigabitEthernet1/0/2
Protocol Pkts In Chars In Pkts Out Chars Out
No traffic sent or received on this interface.
<output truncated>
This is an example of output from the show interfaces capabilities command for an interface.
Switch# show interfaces gigabitethernet1/0/2 capabilities
GigabitEthernet1/0/2
Model: WS-C3750G-24TS
Type: 10/100/1000BaseTX
Speed: 10,100,1000,auto
Duplex: full,auto
Trunk encap. type: 802.1Q,ISL
Trunk mode: on,off,desirable,nonegotiate
Channel: yes
Broadcast suppression: percentage(0-100)
Flowcontrol: rx-(off,on,desired),tx-(none)
Fast Start: yes
QoS scheduling: rx-(not configurable on per port basis),tx-(4q2t)
CoS rewrite: yes
ToS rewrite: yes
UDLD: yes
Inline power: no
SPAN: source/destination
PortSecure: yes
Dot1x: yes
This is an example of output from the show interfaces interface description command when the
interface has been described as Connects to Marketing by using the description interface configuration
command.
Switch# show interfaces gigabitethernet1/0/2 description
Interface Status Protocol Description
Gi1/0/2 up down Connects to Marketing

Table of Contents

Related product manuals