2-473
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show interfaces
This is an example of output from the show interfaces etherchannel command when port channels are
configured on the switch:
Switch# show interfaces etherchannel
----
Port-channel1:
Age of the Port-channel = 03d:20h:17m:29s
Logical slot/port = 10/1 Number of ports = 0
GC = 0x00000000 HotStandBy port = null
Port state = Port-channel Ag-Not-Inuse
Port-channel2:
Age of the Port-channel = 03d:20h:17m:29s
Logical slot/port = 10/2 Number of ports = 0
GC = 0x00000000 HotStandBy port = null
Port state = Port-channel Ag-Not-Inuse
Port-channel3:
Age of the Port-channel = 03d:20h:17m:29s
Logical slot/port = 10/3 Number of ports = 0
GC = 0x00000000 HotStandBy port = null
Port state = Port-channel Ag-Not-Inuse
This is an example of output from the show interfaces interface-id pruning command when pruning is
enabled in the VTP domain:
Switch# show interfaces gigibitethernet1/0/2 pruning
Port Vlans pruned for lack of request by neighbor
Gi1/0/2 3,4
Port Vlans traffic requested of neighbor
Gi1/0/2 1-3
This is an example of output from the show interfaces stats command for a specified VLAN interface.
Switch# show interfaces vlan 1 stats
Switching path Pkts In Chars In Pkts Out Chars Out
Processor 1165354 136205310 570800 91731594
Route cache 0 0 0 0
Total 1165354 136205310 570800 91731594
This is an example of partial output from the show interfaces status command. It displays the status of
all interfaces.
Switch# show interfaces status
Port Name Status Vlan Duplex Speed Type
Fa1/0/1 connected routed a-half a-100 10/100BaseTX
Fa1/0/2 notconnect 121,40 auto auto 10/100BaseTX
Fa1/0/3 notconnect 1 auto auto 10/100BaseTX
Fa1/0/4 notconnect 18 auto auto Not Present
Fa1/0/5 connected 121 a-full a-1000 10/100BaseTX
Fa1/0/6 connected 122,11 a-full a-1000 10/100BaseTX
<output truncated>
Gi1/0/1 notconnect 1 auto auto 10/100/1000BaseTX
Gi1/0/2 connected vl-err-dis a-full a-1000 10/100/1000BaseTX
This is an example of output from the show interfaces status err-disabled command for an interface:
Switch# show interfaces gigabitethernet1/0/2 status err-disabled
Port Name Status Reason Err-disabled Vlans
Gi1/0/2 connected elmi evc down 1,200
To Next Page
Loading...
