Cisco Catalyst 3750 User Manual

B-36
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix B Catalyst 3750 Switch Debug Commands
debug platform cisp
debug platform cisp
Use the debug platform cisp global configuration command to enable platform-level debugging of a
switch that has one or more Client Information Signalling Protocol (CISP)-enabled interfaces. Use the
no form of this command to disable debugging.
debug platform cisp [initialization | interface-configuration | rpc]
no debug platform cisp [initialization | interface-configuration | rpc]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, start a session from the stack master by using the session switch-number privileged EXEC
command and enter enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number <line> privileged EXEC command on the
stack master switch to enable debugging on a member switch without first starting a session.
Related Commands
initialization Enable debugging of the CISP initialization sequence.
interface-configuration Enable debugging of the CISP configuration.
rpc Enable debugging of the CISP RPC requests.
Release Modification
12.2(50)SE This command was introduced.
Command Description
cisp enable Enables Client Information Signalling Protocol
(CISP)
dot1x credentials (global configuration)profile Configures a profile on a supplicant switch.
show cisp Displays CISP information for a specified
interface.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing