2-512
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show controllers cpu-interface
show controllers cpu-interface
Use the show controllers cpu-interface privileged EXEC command to display the state of the CPU
network interface ASIC and the send and receive statistics for packets reaching the CPU.
show controllers cpu-interface [ | {begin | exclude | include} expression]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines This display provides information that might be useful for Cisco technical support representatives
troubleshooting the switch.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is a partial output example from the show controllers cpu-interface command:
Switch# show controllers cpu-interface
cpu-queue-frames retrieved dropped invalid hol-block
----------------- ---------- ---------- ---------- ----------
rpc 4523063 0 0 0
stp 1545035 0 0 0
ipc 1903047 0 0 0
routing protocol 96145 0 0 0
L2 protocol 79596 0 0 0
remote console 0 0 0 0
sw forwarding 5756 0 0 0
host 225646 0 0 0
broadcast 46472 0 0 0
cbt-to-spt 0 0 0 0
igmp snooping 68411 0 0 0
icmp 0 0 0 0
logging 0 0 0 0
rpf-fail 0 0 0 0
queue14 0 0 0 0
cpu heartbeat 1710501 0 0 0
Supervisor ASIC receive-queue parameters
----------------------------------------
queue 0 maxrecevsize 5EE pakhead 1419A20 paktail 13EAED4
queue 1 maxrecevsize 5EE pakhead 15828E0 paktail 157FBFC
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(11)AX This command was introduced.
To Next Page
Loading...
Need help?
General
