Cisco Catalyst 3750 User Manual

2-153
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
dot1x multiple-hosts
dot1x multiple-hosts
This is an obsolete command.
In past releases, the dot1x multiple-hosts interface configuration command was used to allow multiple
hosts (clients) on an IEEE 802.1x-authorized port.
Command History
Related Commands
Release Modification
12.1(11)AX This command was introduced.
12.1(14)EA1 The dot1x multiple-hosts interface configuration command was replaced by
the dot1x host-mode interface configuration command.
Command Description
dot1x host-mode Sets the IEEE 802.1x host mode on a port.
show dot1x Displays IEEE 802.1x statistics, administrative status, and operational status
for the switch or for the specified port.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing