Cisco Catalyst 3750 User Manual

2-828
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
switchport access
switchport access
Use the switchport access interface configuration command to configure a port as a static-access or
dynamic-access port. If the switchport mode is set to access, the port operates as a member of the
specified VLAN. If set to dynamic, the port starts discovery of VLAN assignment based on the
incoming packets it receives. Use the no form of this command to reset the access mode to the default
VLAN for the switch.
switchport access vlan {vlan-id | dynamic}
no switchport access vlan
Syntax Description
Defaults The default access VLAN and trunk interface native VLAN is a default VLAN corresponding to the
platform or interface hardware.
A dynamic-access port is initially a member of no VLAN and receives its assignment based on the packet
it receives.
Command Modes Interface configuration
Command History
Usage Guidelines The no switchport access command resets the access mode VLAN to the appropriate default VLAN for
the device.
The port must be in access mode before the switchport access vlan command can take effect.
An access port can be assigned to only one VLAN.
The VMPS server (such as a Catalyst 6000 series switch) must be configured before a port is configured
as dynamic.
vlan vlan-id Configure the interface as a static access port with the VLAN ID of the
access mode VLAN; the range is 1 to 4094.
vlan dynamic Specify that the access mode VLAN is dependent on the VLAN Membership
Policy Server (VMPS) protocol. The port is assigned to a VLAN based on
the source MAC address of a host (or hosts) connected to the port. The switch
sends every new MAC address received to the VMPS server to get the VLAN
name to which the dynamic-access port should be assigned. If the port
already has a VLAN assigned and the source has already been approved by
the VMPS, the switch forwards the packet to the VLAN.
Release Modification
12.1(11)AX This command was introduced.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing