Cisco Catalyst 3750 - Session

2-475
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
session
session
Use the session privileged EXEC command on the stack master to access a specific stack member or to
access the controller on a Catalyst 3750G Integrated Wireless LAN Controller Switch.
session stack-member-number [processor 1]
Syntax Description
Defaults No default is defined.
Command Modes Global configuration
Command History
Usage Guidelines When you access the member, its member number is appended to the system prompt.
Use the session command from the master to access a member switch.
Use the session command with processor 1 from the master or a standalone switch to access the internal
controller. A standalone switch is always member 1.
Use the processor 1 keyword to change to the controller command-line interface. See the Cisco Wireless
LAN Controller Configuration Guide Release 4.0 for controller configuration information.
Examples This example shows how to access member 6:
Switch(config)# session 6
Switch-6#
This example shows how to access the controller on member 2, which is a Catalyst 3750G wireless LAN
controller switch (standalone or stack master):
Switch# session 2 processor 1
(Cisco Controller)
User:
stack-member-number Specify the member number. The range is 1 to 9.
processor 1 (Optional) Specify the destination processor for the session, that is, the
embedded controller in the Catalyst 3750G Integrated Wireless LAN
Controller Switch. Entering this keyword puts you in the controller CLI.
Note This keyword applies only to a wireless LAN controller switch.
Release Modification
12.1(11)AX This command was introduced.
12.2(25)FZ The processor keyword was added for Catalyst 3750G Integrated Wireless
LAN Controller Switch.