Cisco Catalyst 3750 User Manual

2-821
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
switch priority
switch priority
Use the switch priority global configuration command on the stack master to change the stack member
priority value.
switch stack-member-number priority new-priority-value
Syntax Description
Defaults The default priority value is 1.
Command Modes Global configuration
Command History
Usage Guidelines The new priority value is a factor during a stack-master re-election. Therefore, changing the priority
value does not change the stack master immediately.
Examples This example shows how to change the priority value of stack member 6 to 9:
Switch(config)# switch 6 priority 9
Changing the Switch Priority of Switch Number 6 to 9
Do you want to continue?[confirm]
Related Commands
stack-member-number Specify the current stack member number. The range is 1 to 9.
priority new-priority-value Specify the new stack member priority value. The range is 1 to 15.
Release Modification
12.1(11)AX This command was introduced.
Command Description
reload Reloads the stack member and puts a configuration change into effect.
session Accesses a specific stack member.
switch renumber Changes the stack member number.
show switch Displays information about the switch stack and its stack members.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing