Cisco Catalyst 3750 User Manual

2-687
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show pagp
show pagp
Use the show pagp user EXEC command to display Port Aggregation Protocol (PAgP) channel-group
information.
show pagp [channel-group-number] {counters | dual-active | internal | neighbor} [ | {begin |
exclude | include} expression]]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines You can enter any show pagp command to display the active channel-group information. To display the
nonactive information, enter the show pagp command with a channel-group number.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output are appear.
Examples This is an example of output from the show pagp 1 counters command:
Switch> show pagp 1 counters
Information Flush
Port Sent Recv Sent Recv
--------------------------------------
Channel group: 1
Gi1/0/1 45 42 0 0
Gi1/0/2 45 41 0 0
channel-group-number (Optional) Number of the channel group. The range is 1 to 48.
counters Display traffic information.
dual-active Display the dual-active status.
internal Display internal information.
neighbor Display neighbor information.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(11)AX This command was introduced.
12.2(25)SE The channel-group-number range was changed from 1 to 12 to 1 to 48.
12.2(46)SE The dual-active keyword was added.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing