Cisco Catalyst 3750 User Manual

2-900
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
vlan dot1q tag native
vlan dot1q tag native
Use the vlan dot1q tag native global configuration command to enable tagging of native VLAN frames
on all IEEE 802.1Q trunk ports. Use the no form of this command to return to the default setting.
vlan dot1q tag native
no vlan dot1q tag native
Syntax Description This command has no arguments or keywords.
Defaults The IEEE 802.1Q native VLAN tagging is disabled.
Command Modes Global configuration
Command History
Usage Guidelines When enabled, native VLAN packets going out all IEEE 802.1Q trunk ports are tagged.
When disabled, native VLAN packets going out all IEEE 802.1Q trunk ports are not tagged.
You can use this command with the IEEE 802.1Q tunneling feature. This feature operates on an edge
switch of a service-provider network and expands VLAN space by using a VLAN-in-VLAN hierarchy
and tagging the tagged packets. You must use IEEE 802.1Q trunk ports for sending packets to the
service-provider network. However, packets going through the core of the service-provider network
might also be carried on IEEE 802.1Q trunks. If the native VLANs of an IEEE 802.1Q trunks match the
native VLAN of a tunneling port on the same switch, traffic on the native VLAN is not tagged on the
sending trunk port. This command ensures that native VLAN packets on all IEEE 802.1Q trunk ports are
tagged.
For more information about IEEE 802.1Q tunneling, see the software configuration guide for this
release.
Examples This example shows how to enable IEEE 802.1Q tagging on native VLAN frames:
Switch# configure terminal
Switch (config)# vlan dot1q tag native
Switch (config)# end
You can verify your settings by entering the show vlan dot1q tag native privileged EXEC command.
Release Modification
12.2(25)EA1 This command was introduced.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing