Cisco Catalyst 3750 - Diagnostic Monitor

2-121
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
diagnostic monitor
diagnostic monitor
Use the diagnostic monitor global configuration command to configure the health-monitoring diagnostic
testing. Use the no form of this command to disable testing and return to the default settings.
diagnostic monitor switch {num} test {test-id | test-id-range | all}
diagnostic monitor interval switch {num} test {test-id | test-id-range | all} hh:mm:ss milliseconds
day
diagnostic monitor syslog
diagnostic monitor threshold switch {num} test {test-id | test-id-range | all} count failure count
no diagnostic monitor switch {num} test {test-id | test-id-range | all}
no diagnostic monitor interval switch {num} test {test-id | test-id-range | all}
no diagnostic monitor syslog
no diagnostic monitor threshold switch {num} test {test-id | test-id-range | all} failure count
Syntax Description
Defaults The defaults are as follows:
• Monitoring is disabled.
• syslog is enabled.
switch num Specify the module number. The range is from 1 to 9.
test Specify a test to run.
test-id Identification number for the test to be run; see the “Usage Guidelines”
section for additional information.
test-id-range Range of identification numbers for tests to be run; see the “Usage
Guidelines” section for additional information.
all Run all the diagnostic tests.
interval Specify an interval between tests to be run.
hh:mm:ss Specify the number of time between tests; see the “Usage Guidelines”
section for formatting guidelines.
milliseconds Specify the time in milliseconds; valid values are 0 to 999.
day Specify the number of days between tests; see the “Usage Guidelines”
section for formatting guidelines.
syslog Enable the generation of a syslog message when a health-monitoring test
fails.
threshold Specify the failure threshold.
failure count
count
Specify the failure threshold count.