EasyManuals Logo

Cisco Catalyst 3750 User Manual

Cisco Catalyst 3750
1154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #986 background imageLoading...
Page #986 background image
B-14
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix B Catalyst 3750 Switch Debug Commands
debug ilpower
debug ilpower
Use the debug ilpower privileged EXEC command to enable debugging of the power controller and
Power over Ethernet (PoE) system. Use the no form of this command to disable debugging.
debug ilpower {cdp | controller | event | ha | port | powerman | registries}
no debug ilpower {cdp | controller | event | ha | port | powerman | registries}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines This command is supported only on PoE-capable switches.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
cdp Display PoE Cisco Discovery Protocol (CDP) debug messages.
controller Display PoE controller debug messages.
event Display PoE event debug messages.
ha Display PoE high-availability messages.
port Display PoE port manager debug messages.
powerman Display PoE power management debug messages.
registries Display PoE registries debug messages.
Release Modification
12.1(19)EA1 This command was introduced.
12.2(25)SE The cdp, ha, and powerman keywords were added.
Command Description
show controllers power inline Displays the values in the registers of the specified PoE controller.
show power inline Displays the power status for the specified PoE port or for all PoE
ports.

Table of Contents

Other manuals for Cisco Catalyst 3750

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750 and is the answer not in the manual?

Cisco Catalyst 3750 Specifications

General IconGeneral
Device TypeSwitch
Switching Capacity32 Gbps
Forwarding Rate38.7 Mpps
Stacking Bandwidth32 Gbps
RAM128 MB
Jumbo Frame SupportYes
Switch TypeManaged
ModelCatalyst 3750 Series
Uplink InterfacesSFP
Form FactorRack-mountable
MAC Address Table Size12, 000 entries
Routing ProtocolRIP, OSPF, EIGRP
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesLayer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)PoE
Operating Temperature-5 - 45 °C
Operating Humidity10% to 85% non-condensing

Related product manuals