Cisco Catalyst 3750 - Network-Policy

2-402
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
network-policy
network-policy
Use the network-policy interface configuration command to apply a network-policy profile to an
interface. Use the no form of this command to remove the policy.
network-policy profile number
no network-policy
Syntax Description
Defaults No network-policy profiles are applied.
Command Modes Interface configuration
Command History
Usage Guidelines Use the network-policy profile number interface configuration command to apply a profile to an
interface.
If you first configure a network-policy profile on an interface, you cannot apply the switchport voice
vlan command on the interface. If switchport voice vlan vlan-id is already configured on an interface,
you can apply a network-policy profile on the interface. The interface then has the voice or
voice-signaling VLAN network-policy profile applied on the interface.
Examples This example shows how to apply network-policy profile 60 to an interface:
Switch(config)# interface_id
Switch(config-if)# network-policy profile 60
Related Commands
profile number Specify the network-policy profile number.
Release Modification
12.2(50)SE This command was introduced.
Command Description
network-policy profile (global
configuration)
Creates the network-policy profile.
network-policy profile
(network-policy configuration)
Configures the attributes of network-policy profiles.
show network-policy profile Displays the configured network-policy profiles.