Cisco Catalyst 3750 - Nmsp

2-407
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
nmsp
nmsp
Use the nmsp global configuration command to enable Network Mobility Services Protocol (NMSP) on
the switch. This command is available only when your switch is running the cryptographic (encrypted)
software image. Use the no form of this command to return to the default setting.
nmsp {enable | {notification interval {attachment | location} interval-seconds}}
no nmsp {enable | {notification interval {attachment | location} interval-seconds}}
Syntax Description
Defaults NMSP is disabled.
Command Modes Global configuration
Command History
Usage Guidelines Use the nmsp global configuration command to enable the switch to send NMSP location and
attachment notifications to a Cisco Mobility Services Engine (MSE).
Examples This example shows how to enable NMSP on a switch and set the location notification time to 10
seconds:
Switch(config)#nmsp enable
Switch(config)#nmsp notification interval location 10
enable Enable the NMSP features on the switch.
notification interval Specify the NMSP notification interval.
attachment Specify the attachment notification interval.
location Specify the location notification interval.
interval-seconds Duration in seconds before a switch sends the MSE the location or
attachment updates. The range is 1 to 30; the default is 30.
Release Modification
12.2(50)SE This command was introduced.