EasyManuals Logo

Cisco Catalyst 3750 User Manual

Cisco Catalyst 3750
1154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #129 background imageLoading...
Page #129 background image
2-99
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
cluster member
cluster member
Use the cluster member global configuration command on the cluster command switch to add
candidates to a cluster. Use the no form of the command to remove members from the cluster.
cluster member [n] mac-address H.H.H [password enable-password] [vlan vlan-id]
no cluster member n
Syntax Description
Defaults A newly enabled cluster command switch has no associated cluster members.
Command Modes Global configuration
Command History
Usage Guidelines Enter this command only on the cluster command switch to add a candidate to or remove a member from
the cluster. If you enter this command on a switch other than the cluster command switch, the switch
rejects the command and displays an error message.
You must enter a member number to remove a switch from the cluster. However, you do not need to
enter a member number to add a switch to the cluster. The cluster command switch selects the next
available member number and assigns it to the switch that is joining the cluster.
You must enter the enable password of the candidate switch for authentication when it joins the cluster.
The password is not saved in the running or startup configuration. After a candidate switch becomes a
member of the cluster, its password becomes the same as the cluster command-switch password.
If a switch does not have a configured hostname, the cluster command switch appends a member number
to the cluster command-switch hostname and assigns it to the cluster member switch.
If you do not specify a VLAN ID, the cluster command switch automatically chooses a VLAN and adds
the candidate to the cluster.
n The number that identifies a cluster member. The range is 0 to 15.
mac-address H.H.H MAC address of the cluster member switch in hexadecimal format.
password enable-password Enable password of the candidate switch. The password is not
required if there is no password on the candidate switch.
vlan vlan-id (Optional) VLAN ID through which the candidate is added to the
cluster by the cluster command switch. The range is 1 to 4094.
Release Modification
12.1(11)AX This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3750

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750 and is the answer not in the manual?

Cisco Catalyst 3750 Specifications

General IconGeneral
Device TypeSwitch
Switching Capacity32 Gbps
Forwarding Rate38.7 Mpps
Stacking Bandwidth32 Gbps
RAM128 MB
Jumbo Frame SupportYes
Switch TypeManaged
ModelCatalyst 3750 Series
Uplink InterfacesSFP
Form FactorRack-mountable
MAC Address Table Size12, 000 entries
Routing ProtocolRIP, OSPF, EIGRP
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesLayer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)PoE
Operating Temperature-5 - 45 °C
Operating Humidity10% to 85% non-condensing

Related product manuals