Cisco Catalyst 3750 User Manual

2-864
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
switchport voice vlan
switchport voice vlan
Use the switchport voice vlan interface configuration command to configure voice VLAN on the port.
Use the no form of this command to return to the default setting.
switchport voice vlan {vlan-id | dot1p | none | untagged}
no switchport voice vlan
Syntax Description
Defaults The switch default is not to automatically configure the telephone (none).
The telephone default is not to tag frames.
Command Modes Interface configuration
Command History
Usage Guidelines You should configure voice VLAN on Layer 2 access ports.
You must enable Cisco Discovery Protocol (CDP) on the switchport connected to the Cisco IP phone for
the switch to send configuration information to the phone. CDP is enabled by default globally and on
the interface.
Before you enable voice VLAN, we recommend that you enable quality of service (QoS) on the switch
by entering the mls qos global configuration command and configure the port trust state to trust by
entering the mls qos trust cos interface configuration command.
When you enter a VLAN ID, the IP phone forwards voice traffic in IEEE 802.1Q frames, tagged with
the specified VLAN ID. The switch puts IEEE 802.1Q voice traffic in the voice VLAN.
When you select dot1q, none, or untagged, the switch puts the indicated voice traffic in the access
VLAN.
In all configurations, the voice traffic carries a Layer 2 IP precedence value. The default is 5 for voice
traffic.
vlan-id Specify the VLAN to be used for voice traffic. The range is 1 to 4094. By default, the
IP phone forwards the voice traffic with an IEEE 802.1Q priority of 5.
dot1p Configure the telephone to use IEEE 802.1p priority tagging and uses VLAN 0 (the
native VLAN). By default, the Cisco IP phone forwards the voice traffic with an
IEEE
802.1p priority of 5.
none Do not instruct the IP telephone about the voice VLAN. The telephone uses the
configuration from the telephone key pad.
untagged Configure the telephone to send untagged voice traffic. This is the default for the
telephone.
Release Modification
12.1(11)AX This command was introduced.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing