EasyManuals Logo

Cisco Catalyst 3750 User Manual

Cisco Catalyst 3750
1154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #512 background imageLoading...
Page #512 background image
2-482
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
setup express
setup express
Use the setup express global configuration command to enable Express Setup mode. Use the no form
of this command to disable Express Setup mode.
setup express
no setup express
Syntax Description This command has no arguments or keywords.
Defaults Express Setup is enabled.
Command Modes Global configuration
Command History
Usage Guidelines When Express Setup is enabled on a new (unconfigured) switch, pressing the Mode button for 2 seconds
activates Express Setup. You can access the switch through an Ethernet port by using the IP address
10.0.0.1 and then can configure the switch with the web-based Express Setup program or the
command-line interface (CLI)-based setup program.
When you press the Mode button for 2 seconds on a configured switch, the LEDs above the Mode button
start blinking. If you press the Mode button for a total of 10 seconds, the switch configuration is deleted,
and the switch reboots. The switch can then be configured like a new switch, either through the
web-based Express Setup program or the CLI-based setup program.
Note As soon as you make any change to the switch configuration (including entering no at the beginning of
the CLI-based setup program), configuration by Express Setup is no longer available. You can only run
Express Setup again by pressing the Mode button for 10 seconds. This deletes the switch configuration
and reboots the switch.
If Express Setup is active on the switch, entering the write memory or copy running-configuration
startup-configuration privileged EXEC commands deactivates Express Setup. The IP address 10.0.0.1
is no longer valid on the switch, and your connection using this IP address ends.
The primary purpose of the no setup express command is to prevent someone from deleting the switch
configuration by pressing the Mode button for 10 seconds.
Examples This example shows how to enable Express Setup mode:
Switch(config)# setup express
Release Modification
12.1(14)EA1 This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3750

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750 and is the answer not in the manual?

Cisco Catalyst 3750 Specifications

General IconGeneral
Device TypeSwitch
Switching Capacity32 Gbps
Forwarding Rate38.7 Mpps
Stacking Bandwidth32 Gbps
RAM128 MB
Jumbo Frame SupportYes
Switch TypeManaged
ModelCatalyst 3750 Series
Uplink InterfacesSFP
Form FactorRack-mountable
MAC Address Table Size12, 000 entries
Routing ProtocolRIP, OSPF, EIGRP
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesLayer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)PoE
Operating Temperature-5 - 45 °C
Operating Humidity10% to 85% non-condensing

Related product manuals