EasyManuals Logo

Cisco Catalyst 3750 User Manual

Cisco Catalyst 3750
1154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #327 background imageLoading...
Page #327 background image
2-297
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
ipv6 traffic-filter
ipv6 traffic-filter
Use the ipv6 traffic-filter interface configuration command to filter IPv6 traffic on an interface. The
type and direction of traffic that you can filter depends on the image running on the switch stack. Use
the no form of this command to disable the filtering of IPv6 traffic on an interface.
ipv6 traffic-filter access-list-name {in | out}
no ipv6 traffic-filter access-list-name {in | out}
Note This command is available only if you have configured a dual IPv4 and IPv6 Switch Database
Management (SDM) template on the switch.
Syntax Description
Defaults Filtering of IPv6 traffic on an interface is not configured.
Command Modes Interface configuration
Command History
Usage Guidelines To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default |
vlan) global configuration command and reload the switch.
You can use the ipv6 traffic-filter command on physical interfaces (Layer 2 or Layer 3 ports), Layer 3
port channels, or switch virtual interfaces (SVIs).
You can apply an ACL to outbound or inbound traffic on Layer 3 interfaces (port ACLs), or to inbound
traffic on Layer
2 interfaces (router ACLs).
If any port ACL (IPv4, IPv6, or MAC) is applied to an interface, that port ACL is used to filter packets,
and any router ACLs attached to the SVI of the port VLAN are ignored.
access-list-name Specify an IPv6 access name.
in Specify incoming IPv6 traffic.
out Specify outgoing IPv6 traffic.
Note The out keyword is not supported for Layer 2 interfaces (port
ACLs).
Release Modification
12.2(25)SED This command was introduced.
12.2(35)SE Support was added for inbound Layer 3 management traffic (router ACLs)
in the IP services and IP base images.

Table of Contents

Other manuals for Cisco Catalyst 3750

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750 and is the answer not in the manual?

Cisco Catalyst 3750 Specifications

General IconGeneral
Device TypeSwitch
Switching Capacity32 Gbps
Forwarding Rate38.7 Mpps
Stacking Bandwidth32 Gbps
RAM128 MB
Jumbo Frame SupportYes
Switch TypeManaged
ModelCatalyst 3750 Series
Uplink InterfacesSFP
Form FactorRack-mountable
MAC Address Table Size12, 000 entries
Routing ProtocolRIP, OSPF, EIGRP
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesLayer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)PoE
Operating Temperature-5 - 45 °C
Operating Humidity10% to 85% non-condensing

Related product manuals