Cisco Catalyst 3750 User Manual

2-504
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show cisp
show cisp
Use the show cisp privileged EXEC command to display CISP information for a specified interface.
show cisp {[interface interface-id] | clients | summary} | {[begin | exclude | include} expression]}
Syntax Description
Command Modes Global configuration
Command History
Examples This example shows output from the show cisp interface command:
WS-C3750E-48TD#show cisp interface fast 0
CISP not enabled on specified interface
This example shows output from the show cisp summary command:
CISP is not running on any interface
Related Commands
clients (Optional) Display CISP client details
interface interface-id (Optional) Display CISP information about the specified interface. Valid
interfaces include physical ports and port channels.
summary (Optional) Display
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(50)SE This command was introduced.
Command Description
dot1x credentials profile Configure a profile on a supplicant switch
cisp enable Enable Client Information Signalling Protocol (CISP)

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing