Cisco Catalyst 3750 - Ip Access-Group

2-200
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
ip access-group
ip access-group
Use the ip access-group interface configuration command to control access to a Layer 2 or Layer 3
interface. Use the no form of this command to remove all access groups or the specified access group
from the interface.
ip access-group {access-list-number | name} {in | out}
no ip access-group [access-list-number | name] {in | out}
Syntax Description
Defaults No access list is applied to the interface.
Command Modes Interface configuration
Command History
Usage Guidelines You can apply named or numbered standard or extended IP access lists to an interface. To define an
access list by name, use the ip access-list global configuration command. To define a numbered
access
list, use the access list global configuration command. You can used numbered standard access
lists ranging from 1 to 99 and 1300 to 1999 or extended access lists ranging from 100 to 199 and
2000
to 2699.
You can use this command to apply an access list to a Layer 2 or Layer 3 interface. However, note these
limitations for Layer 2 interfaces (port ACLs):
• You can only apply ACLs in the inbound direction; the out keyword is not supported for Layer 2
interfaces.
• You can only apply one IP ACL and one MAC ACL per interface.
• Layer 2 interfaces do not support logging; if the log keyword is specified in the IP ACL, it is
ignored.
• An IP ACL applied to a Layer 2 interface only filters IP packets. To filter non-IP packets, use the
mac access-group interface configuration command with MAC extended ACLs.
access-list-number The number of the IP access control list (ACL). The range is 1 to 199 or
1300 to 2699.
name The name of an IP ACL, specified in the ip access-list global configuration
command.
in Specify filtering on inbound packets.
out Specify filtering on outbound packets. This keyword is valid only on
Layer
3 interfaces.
Release Modification
12.1(11)AX This command was introduced.
12.1(14)EA1 This command support was extended to Layer 2 interfaces.