Cisco Catalyst 3750 User Manual

2-409
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
nmsp attachment suppress
nmsp attachment suppress
Use the nmsp attachment suppress interface configuration mode command to suppress the reporting
of attachment information from a specified interface. This command is available only when your switch
is running the cryptographic (encrypted) software image. Use the no form of this command to return to
the default setting.
nmsp attachment suppress
no nmsp attachment suppress
Syntax Description This command has no arguments or keywords.
Defaults This command has no default setting.
Command Modes Interface configuration
Command History
Usage Guidelines Use the nmsp attachment suppress interface configuration command to configure an interface to not
send location and attachment notifications to a Cisco Mobility Services Engine (MSE).
Examples This example shows how to configure an interface to not send attachment information to the MSE:
Switch(config)# switch interface interface-id
Switch(config-if)# nmsp attachment suppress
Related Commands
Release Modification
12.2(50)SE This command was introduced.
Command Description
nmsp Enables Network Mobility Services Protocol (NMSP) on the
switch.
show nmsp Displays the NMSP information.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing