2-271
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
ipv6 access-list
ipv6 access-list
Use the ipv6 access-list global configuration command to define an IPv6 access list and to place the
switch in IPv6 access list configuration mode. To remove the access list, use the no form of this
command.
ipv6 access-list access-list-name
no ipv6 access-list access-list-name
Note This command is available only if you have configured a dual IPv4 and IPv6 Switch Database
Management (SDM) template on the switch stack.
Syntax Description
Defaults No IPv6 access list is defined.
Command Modes Global configuration
Command History
Usage Guidelines To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default |
vlan) global configuration command and reload the switch.
The ipv6 access-list command is similar to the ip access-list command, except that it is IPv6-specific.
Note IPv6 ACLs are defined by a unique name (IPv6 does not support numbered ACLs). An IPv4 ACL and
an IPv6 ACL cannot share the same name.
See the ipv6 access-list and permit (IPv6 access-list configuration) commands for more information
on filtering IPv6 traffic based on IPv6 option headers and optional, upper-layer protocol-type
information. See the “Examples” section for an example of a translated IPv6 ACL configuration.
access-list-name Name of the IPv6 access list. Names cannot contain a space or quotation
mark or begin with a numeric.
Release Modification
12.2(25)SED This command was introduced.
To Next Page
Loading...
