Cisco Catalyst 3750 User Manual

2-902
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
vlan filter
vlan filter
Use the vlan filter global configuration command to apply a VLAN map to one or more VLANs. Use
the no form of this command to remove the map.
vlan filter mapname vlan-list {list | all}
no vlan filter mapname vlan-list {list | all}
Syntax Description
Defaults There are no VLAN filters.
Command Modes Global configuration
Command History
Usage Guidelines To avoid accidentally dropping too many packets and disabling connectivity in the middle of the
configuration process, we recommend that you completely define the VLAN access map before applying
it to a VLAN.
For more information about VLAN map entries, see the software configuration guide for this release.
Examples This example applies VLAN map entry map1 to VLANs 20 and 30:
Switch(config)# vlan filter map1 vlan-list 20, 30
This example shows how to delete VLAN map entry mac1 from VLAN 20:
Switch(config)# no vlan filter map1 vlan-list 20
You can verify your settings by entering the show vlan filter privileged EXEC command.
mapname Name of the VLAN map entry.
list The list of one or more VLANs in the form tt, uu-vv, xx, yy-zz, where spaces
around commas and dashes are optional. The range is 1 to 4094.
all Remove the filter from all VLANs.
Release Modification
12.1(11)AX This command was introduced.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing