Cisco Catalyst 3750 - Show Idprom

2-562
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show idprom
show idprom
Use the show idprom user EXEC command to display the IDPROM information for the specified
interface.
show idprom {interface interface-id} [detail] [ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines This command applies only to 10-Gigabit Ethernet interfaces.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show idprom interface tengigabitethernet1/0/1 command for
the 10-Gigabit Ethernet interface. It shows the XENPAK module serial EEPROM contents.
For information about the EEPROM map and the field descriptions for the display, see the XENPAK
multisource agreement (MSA) at these sites:
http://www.xenpak.org/MSA/XENPAK_MSA_R2.1.pdf
http://www.xenpak.org/MSA/XENPAK_MSA_R3.0.pdf
interface interface-id Display the IDPROM information for the specified 10-Gigabit Ethernet
interface.
detail (Optional) Display detailed hexidecimal IDPROM information.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(20)SE1 This command was introduced.