Cisco Catalyst 3750 User Manual

2-15
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
archive tar
archive tar
Use the archive tar privileged EXEC command to create a tar file, list files in a tar file, or extract the
files from a tar file.
archive tar {/create destination-url flash:/file-url} | {/table source-url} | {/xtract source-url
flash:/file-url [dir/file...]}
Syntax Description /create destination-url
flash:/file-url
Create a new tar file on the local or network file system.
For destination-url, specify the destination URL alias for the local or
network file system and the name of the tar file to create. These options
are supported:
• The syntax for the local flash filesystem:
flash:
• The syntax for the FTP:
ftp:[[//username[:password]@location]/directory]/tar-filename.tar
• The syntax for an HTTP server:
http://[[username:password]@]{hostname |
host-ip}[/directory]/image-name.tar
• The syntax for a secure HTTP server:
https://[[username:password]@]{hostname |
host-ip}[/directory]/image-name.tar
• The syntax for the Remote Copy Protocol (RCP) is:
rcp:[[//username@location]/directory]/tar-filename.tar
• The syntax for the TFTP:
tftp:[[//location]/directory]/tar-filename.tar
The tar-filename.tar is the tar file to be created.
For flash:/file-url, specify the location on the local flash file system from
which the new tar file is created.
An optional list of files or directories within the source directory can be
specified to write to the new tar file. If none are specified, all files and
directories at this level are written to the newly created tar file.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing