EasyManuals Logo

Cisco Catalyst 3750 User Manual

Cisco Catalyst 3750
1154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #544 background imageLoading...
Page #544 background image
2-514
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show controllers ethernet-controller
show controllers ethernet-controller
Use the show controllers ethernet-controller privileged EXEC command without keywords to display
per-interface send and receive statistics read from the hardware. Use with the phy keyword to display
the interface internal registers or the port-asic keyword to display information about the port ASIC.
show controllers ethernet-controller [interface-id] [phy [detail]] [port-asic {configuration |
statistics}] [fastethernet 0][ | {begin | exclude | include} expression]
Syntax Description
Command Modes Privileged EXEC (only supported with the interface-id keywords in user EXEC mode)
Command History
Usage Guidelines This display without keywords provides traffic statistics, basically the RMON statistics for all interfaces
or for the specified interface.
When you enter the phy or port-asic keywords, the displayed information is useful primarily for Cisco
technical support representatives troubleshooting the switch.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
interface-id The physical interface (including type, stack member, module, and port number).
phy (Optional) Display the status of the internal registers on the switch physical layer
device (PHY) for the device or the interface. This display includes the operational
state of the automatic medium-dependent interface crossover (auto-MDIX)
feature on an interface.
detail (Optional) Display details about the PHY internal registers.
port-asic (Optional) Display information about the port ASIC internal registers.
configuration Display port ASIC internal register configuration.
statistics Display port ASIC statistics, including the Rx/Sup Queue and miscellaneous
statistics.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(11)AX This command was introduced.
12.2(20)SE The display was enhanced to show the XENPAK module serial EEPROM
contents.

Table of Contents

Other manuals for Cisco Catalyst 3750

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750 and is the answer not in the manual?

Cisco Catalyst 3750 Specifications

General IconGeneral
Device TypeSwitch
Switching Capacity32 Gbps
Forwarding Rate38.7 Mpps
Stacking Bandwidth32 Gbps
RAM128 MB
Jumbo Frame SupportYes
Switch TypeManaged
ModelCatalyst 3750 Series
Uplink InterfacesSFP
Form FactorRack-mountable
MAC Address Table Size12, 000 entries
Routing ProtocolRIP, OSPF, EIGRP
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesLayer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)PoE
Operating Temperature-5 - 45 °C
Operating Humidity10% to 85% non-condensing

Related product manuals