Cisco Catalyst 3750 User Manual

C-18
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix C Catalyst 3750 Switch Show Platform Commands
show platform ipv6 unicast
show platform ipv6 unicast
Use the show platform ipv6 unicast privileged EXEC command to display platform-dependent IPv6
unicast routing information. This command is available only if the stack is running the IP services image.
show platform ipv6 unicast {adjacency [ipv6-prefix] | backwalk {adjacency | loadbalance} |
compress ipv6-prefix/prefix length | interface | loadbalance | mpath | retry {adjacency |
route} | route [ipv6-prefix/prefix length | tcam] [detail] | statistics | table [detail] | trace}
[| {begin | exclude | include} expression]
Syntax Description
Command Modes Privileged EXEC
adjacency Display IPv6 adjacency information for the switch or for the specified IPv6
network.
ipv6-prefix (Optional) The IPv6 network to be displayed. This argument must be in the
form documented in RFC 2373 where the address is specified in hexadecimal
using 16-bit values between colons.
backwalk {adjacency
| loadbalance}
Display IPv6 backwalk information.
• adjacency—Display adjacency backwalk information.
• loadbalance—Display backwalk load balance information.
compress
ipv6-prefix/prefix
length
Display IPv6 prefix compression information.
• ipv6-prefix—The IPv6 network.
• /prefix length—The length of the IPv6 network prefix. A decimal value
from 0 to 128 that shows how many of the high-order contiguous bits of
the address comprise the prefix (the network portion of the address). A
slash mark must precede the decimal value.
interface Display IPv6 interface information.
loadbalance Display IPv6 loadbalance information
mpath Display IPv6 multipath information
retry {adjacency |
route}
Display IPv6 retry information.
• adjacency—Display IPv6 adjacency retry information.
• route—Display IPv6 route retry information.
route Display IPv6 route information.
tcam (Optional) Display the IPv6 TCAM route table information.
detail (Optional) Display detailed IPv6 route information.
statistics Display IPv6 accumulated statistics.
table Display IPv6 unicast table information.
trace Display IPv6 unicast traces.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing